• Lun - Ven 8:00 - 12:00 / 13:30 - 17:30
  • + 39 045 8510142
  • info@lbzweb.it

PNEUMATIC STRETCHERS


  Description

PNEUMATIC STRETCHERS

  • Can be installed in drying/wet section.
  • Highly compact can be installed in any position.
  • Made in stainless steel or painted steel.
  • Allow a steady stretch thanks to 2 pneumatic cylinders and a syncroniser shaft which guarantees alignment.
  • Available standard 800-1000 mm strokes and various sizes according to machine width.
  Request information about this product

    Your Name (required)

    Your Email (required)

    Subject

    Your Message

    Read more

    AUTOMATIC STRETCHERS WITH LOAD CELL


      Description

    AUTOMATIC STRETCHERS WITH LOAD CELL

    • Can be installed in drying/wet section.
    • Highly compact can be installed in any position.
    • Made in stainless steel or painted steel.
    • Available standard 800-1000 mm strokes and various sizes according to the machine width.
    • Inserted into the line for the production of paper, its specific function is to maintain the tension of
    • the wire/felt during the sliding phase of the paper, in non-stop production.
    • As the wire/felt becomes loose, the load cell installed in the wire/felt circuit or installed on the stretcher, detects the tension and sends the signal to the PLC of the control panel which moves the tensioning roll until the wire/felt automatically returns to the set tension.
    • The correct tension of the wire/felt improves the quality of the paper.
      Request information about this product

      Your Name (required)

      Your Email (required)

      Subject

      Your Message

      Read more

      AUTOMATIC FELT/WIRE GUIDES


        Description

      AUTOMATIC FELT/WIRE GUIDES

      • They can be installed in drying and wet section.
      • They have small dimensions and can be installed in any position./li>
      • Made in stainless steel or painted steel.
      • With pneumatic actuators high temperature resistant to be used in drying section.
      • They can be combined with a manual regulator to be installed on the service side of the machine (or under the automatic guide device) in order to allow operators any manual intervention.
      • Different sizes available according to the different uses.
        Request information about this product

        Your Name (required)

        Your Email (required)

        Subject

        Your Message

        Read more